How to Wash Your Hair When You Use Hair Fibres

Silicone scalp brush

If you use hair fibres daily, how you wash your hair matters. A good routine takes the fibres out cleanly, keeps your scalp comfortable and means each application starts from a fresh base. Here is a simple approach.

This is general advice about cosmetic products. If you have an itchy, sore or flaky scalp that doesn't settle, speak to your GP or pharmacist.

Do hair fibres need special washing?

No special products are needed. Hair fibres are designed to wash out with normal shampooing. What matters is washing thoroughly enough that no fibres, powder or hold spray are left on your scalp, because build-up can make hair look dull and your scalp feel uncomfortable.

A simple washing routine

  1. Brush first. Gently brush your dry hair to loosen fibres and reduce what goes down the plughole.
  2. Wet your hair thoroughly with lukewarm water. Very hot water can irritate your scalp.
  3. Shampoo twice. The first wash lifts fibres and product, and the second cleans your scalp.
  4. Massage gently. Use your fingertips or a soft silicone scalp brush in small circles to lift away fibres and buildup. Don't scratch or press hard.
  5. Rinse well. Make sure all the shampoo is gone.
  6. Condition the lengths, not the roots, so fine hair isn't weighed down.
  7. Dry gently. Pat with a towel rather than rubbing, then let your hair dry fully before you apply fibres again.

How often should you wash?

Most people wash daily or every other day when they use fibres, depending on how oily their scalp is. If you apply fibres every day, washing at least every second day helps keep your scalp clean. Listen to your scalp: if it feels itchy, tight or greasy, adjust your routine.

Occasional deep clean

If hold spray or styling products build up, a clarifying shampoo once a week or two can reset your hair. Don't overdo it, because strong shampoos can dry your scalp.

What to avoid

  • Scrubbing hard or using your nails
  • Heavy oils or thick conditioners at the roots
  • Going to bed with fibres and lots of hair spray still in your hair, if it leaves your scalp feeling irritated
  • Very hot showers

Protect your pillow and clothes

If you apply fibres the night before an event, brush your hair gently before bed to remove loose fibres. A dark pillowcase can hide any transfer.

When to speak to a professional

If your scalp becomes red, painful, very itchy or flaky, or if you notice patchy hair loss, stop using products that seem to irritate it and ask your GP or pharmacist for advice.

The bottom line

Washing hair fibres out is simple. Brush first, shampoo twice, massage gently, rinse well and start fresh next time. A little consistency keeps your scalp comfortable and your hair looking its best.